Flexi Plate with Textured ULTEM PEI - Creality CR-10S Pro - 320 x 310

Printer Fits:
• Anycubic Kobra Plus
• Comgrow T300
• Creality CR-10S Pro
• Creality CR-10S Pro V2
• Creality CR-10S Pro V3
• Creality CR-X
• Creality Ender 3 Max
• Ender 3 Max Neo
• Formbot Troodon 300
• goofoo Nova
• Sovol SV06 Plus*
• Sovol SV07 Plus*

May fit:
• Anycubic Mega X
• Artillery X4 Plus S1**
• Creality CR10 Smart
• Kywoo Tycoon Max
• Sovol SV04

*for the SV06 Plus and SV07 Plus, you will either have to remove the two alignment screws at the rear of the build plate or mount the Flexi Plate 5 mm over the front of the bed.

**No alignment holes.

Do you have a printer similar to what's listed under Printer Fits or May Fit?
If you have a printer similar to the one described above and believe our solution could work for your printer, please follow our easy instructions on measuring your build plate. Let us know if your printer matches our specifications or is even close! We’d love to hear about it, and you might even receive a discount on Wham Bam® merchandise for your efforts. Click here for more info.

Includes:

• 1 Powder Painted Ultem™ PEI Flexi Plate

Dimensions:

• 320 x 310 mm
• 320 mm in Y direction
• 310 mm in X direction, tab side
• Flexi Plate 0.4 mm
• ULTEM™ PEI Build Surface 0.12 mm, on each side

Sensor Compatibility:

• Eddy current mesh
• Optical sensors
• Touch sensors
• Inductive
• Capacitive
• Cartographer

If your machine has automatic bed leveling, run the leveling process and set your gap such that the first layer is well squished. For more details on achieving the right first layer squish, refer to this bed leveling guide.

If your printer uses manual leveling, follow the same guide for instructions on the leveling process.

Powder Painted Ultem™ PEI Best Practice Use:

Cleaning Before & After prints
After every print, we suggest wiping with isopropyl alcohol and a fresh paper towel. If you have small bits, such as purge lines, stuck to the surface you can try with a steel spatula with corners rounded to carefully remove these. Do not use Acetone as this will damage the surface.

Longterm Contaminants cleaning:
Should the PEI ever lose its grip, you may also try common dish detergent or vinegar and clean with water as these help break fats added to filaments with effects. You can also lightly pass over the plate with 600 grit wet dry sandpaper to revitalize, then clean with IPA and a fresh paper towel.